PVC Strip Curtain - DIY Installation Guide for Bolt-on, Face Fix System STEP 2 of 2 vi/ Secure the brackets with track attached to the brickwork and concrete with rawl-bolts to steelwork with high tensile nuts and bolts and to timber with coach screws or large gauge wood screws vii/ Push each pre drilled strip over the bolts with the concave side facing the track viii/ Hold each strip to the track using the aluminium plate, thread the M8 nuts onto the bolts but do not tighten fully ix/ Slide the strip to the desired starting place before tightening the nuts x/ If you are including Red warning strips remember to position these first xi/ To achieve 100% overlap each strip must butt up to the next on both sides of the track: xii/ For 50% overlap each strip should be placed at a distance from each other that it overlaps by a quarter of the width of each strip: xiii/ Finally trim the bottom of each strip to the desired length using a sharp knife Note It may not be possible to acheive the desired overlap - this will depend on the width of your top track. Back to Step 1 |
Back to Step 1 |