PVC Strip Curtain - DIY Installation Guide for Bolt-on, Soffit Fix System
How do I install made to measure Bolt-on, Soffit Fix PVC Strip Curtains?
The following instruction guide demonstrates how to get professional results from our made to measure Bolt-on, Soffit Fix - PVC strip curtains.
- Slide the M8 nuts into the centre slot and along the track
- Place the brackets over the M8 nuts and tighten into position using the countersunk bolts
- Place the brackets no more than 1200mm apart and no more than 200mm in from each end of the track
- The "L" shapes brackets should be arranged so that each alternate bracket is facing the opposite side of the track
- Slide the required number of M8 bolts down both sides of the track ready to receive the curtain strips
- Secure the brackets with track attached to brickwork and concrete with raw-bolts, to steelwork with high tensile nuts & bolts and to timber with coach screws or large gauge wood screws
- Push each pre drilled pvc strip over the bolts with the concave side facing the track
- Hold each strip to the track using the aluminium plate, thread the M8 nuts onto the bolt but do not tighten fully
- Slide the strip to the desired starting place before tightening the nuts
- If you are including Red warning strips remember to position these first
- Correct overlap*:
- To achieve 100% overlap each strip must butt up to the next on both sides of the track, like this:
- For 50% overlap each strip should be placed at a distance from each other that it overlaps by a quarter of the width of each strip, like this: